Thanks for visiting Machinery Directive. Please remember to bookmark this page Gps Antenna. If you found what your looking for, then don"t forget to click an appreciation button above for this post.
![]() Trimble EZ Guide 250 GPS Lightbar w/ AG15 Antenna Upgrade US $1,599.99
|
![]() Raven Cruizer II w/ Helix Antenna Lightbar GPS Mapping Weather Resistant US $1,950.00
|
Gps Antenna
Four Main Effects on GPS Antenna Performance
1, Ceramic Wafer: ceramic powders and sintering processes directly affect the quality of GPS Antenna performance. Now the market ceramic used is mainly in 25 × 25,18 × 18,15 × 15,12 × 12. Ceramic chip area is larger, the larger the dielectric constant, the higher the resonant frequency and the better is the receiving. Most of the ceramic wafer design is square, to ensure that the resonance in the XY direction is consistent, in order to achieve signal receiving well-distributed.
2, Silver Plate: the silver layer of ceramic antenna can affect the resonant frequency. Ideal frequency of GPS ceramic should fall 1575.42MHz on the nose, but the antenna frequency is vulnerable to affect by the surrounding environment, especially built in the machine, Therefore, have to adjust the silver-coated form, to make sure the frequency remained at 1575.42MHz .
3, The Feed Point: ceramic antenna collects resonance signal through the feed point and then sent to the backend. Since the antenna impedance matching reasons, feed is generally not in the center of the antenna, but doing minor adjustments in the XY direction. This impedance matching method is simple and has no extra cost. Move only in the uniaxial direction is called a single partial antenna, do move in two axes are referred to as double-side.
4, The amplifier circuit: to bear the shape and size of the PCB ceramic antenna. As GPS has the characteristics of ground bounce, when the background is 7cm × 7cm without a break earth, patch antenna performance can be to the limits. Although restriction by the appearance of the exterior structure and other factors, but try to maintain a considerable size and the same shape. Amplifier gain selection should be with the back-end LNA gain. Before the required signal input of Sirf's GSC3F, total gain shall not exceed 29dB, otherwise saturated signal will result in self-excited.
About the Author
www.epathchina.com is a professional B2C E-commerce website serving global buyers. It is owned by EPATHCHINA LIMITED - China Wholesale & Dropship Supplier. ePathChina Online Shop Sell Electronics: GPS Antenna, Wholesale GPS Receiver, GPS Navigation, GPS Tracker, GPS Jammer and More Other Consumer Electronics Products!

If you are looking for a different item here are a list of related products on Machinery Directive, please check out the following:






































